Blue Rhino SkeeterVac SV-15 Bedienungshandbuch PDF herunterladen (Seite 7)

Contact 1.888.753.7137 for assistance. Do not return to place of purchase.

page no.

Lighting

Caution: Keep this appliance area clear

and free from combustible materials,

gasoline and other flammable vapors

and liquids.

Caution: Do not obstruct the flow of

combustion and ventilation air.

1. Read instructions before lighting.

2. Connect LP gas tank per “Installing LP Gas Tank”

section.

3. Remove rain cover by turning counterclockwise.

4. Turn LP gas tank valve slowly to ‘’OPEN’’

5. IMMEDIATELY press and hold igniter button down

until you hear a “POP” sound indicating ignition.

Normally occurs within 20 seconds (Figure 4).

6. Continue to hold control valve button for 30 seconds.

7. The needle on the engine gauge should begin to

move into the “Green” zone indicating ignition is

complete.

CAUTION: If engine fails to light, shut

LP gas off at tank and wait 5 minutes

before attempting to restart the engine

by following the lighting instructions.

Turning Off

1. Turn LP gas tank valve to “CLOSED”.

Note: A “poof” sound is normal as the last of the

LP gas is burned.

2. Disconnect LP gas tank per “Disconnect LP Gas

Tank” instructions.

CAUTION: The gas supply must be

turned off at the LP-gas tank when this

outdoor gas appliance is not in use.

Cleaning and Care

CAUTION: All cleaning and maintenance

should be done when SkeeterVac

is cool and with the fuel supply

disconnected.

CAUTION: DO NOT clean any

SkeeterVac

part in a self cleaning

oven.

CAUTION: This SkeeterVac

should be

thoroughly cleaned and inspected on a

regular basis.

Notices

1. This SkeeterVac

should be thoroughly cleaned

and inspected on a regular basis.

2. Abrasive cleaners will damage this product.

3. Never use oven cleaner to clean any part of

SkeeterVac

Before Each Use:

1. Keep the SkeeterVac

area clean and free from any combustible materials, gasoline, and

other flammable vapors and liquids.

2. Do not obstruct the flow of the combustion of LP and the ventilation air.

3. Keep the ventilation opening(s) of the LP gas tank area free and clear from debris.

4. See “Cleaning Instructions” for proper cleaning instructions.

Cleaning Instructions / Routine Service

To ensure maximum performance and to lengthen the life of your SkeeterVac

device, perform

these steps each time your tank is empty. This model will consume a standard 20 lb. LP gas

tank every 28-30 days.

Note: While unit is in use, check the following every 2-3 days:

• Check WaveDrawer™ and clean (if necessary).

• Check air passages for blockage.

1. Turn LP gas tank valve to “CLOSED”.

2. Disconnect hose/regulator gas line from tank by turning knob counterclockwise.

3. Remove rain cover from top of SkeeterVac

4. Remove used TacTrap™ and dispose of properly.

5. Remove WaveDrawer™, empty and clean.

6. Remove used Finetune

lure (if necessary) and properly dispose.

Note: Finetune

Lure lasts 60 days.

• Clean clogged roof gutters on an annual basis.

• Turn over plastic wading pools when not in use.

• Turn over wheelbarrows, empty planters, or children’s toys when not in use.

• Don’t allow water to stagnate in birdbaths.

• Aerate ornamental pools or stock them with fish.

• Clean and chlorinate swimming pools that are not being used. Don’t forget that mosquitoes

breed in the water that collects on swimming pool covers.

• Use landscaping features or drainage tools to eliminate standing water that collects in low

spots on your property.

Helpful Links

More information about mosquitoes in the United States and Canada can be found on the

following sites, among many others.

• The American Mosquito Control Association: http://www.mosquito.org

• US Environmental Protection Agency: http://www.epa.gov/pesticides/health/mosquitoes

• National Center for Infectious Diseases: http://www.cdc.gov . Search for “Mosquitoes”.

• Canadian Pest Management Regulatory Agency: http://www.hc-sc.gc.ca/pmra-arla/english/

pdf/pnotes/mosquitos-e.pdf

None of the agencies listed above is an endorser of the SkeeterVac

device, and inclusion on

the list above does not signify that they endorse the SkeeterVac

device. Links provided for

customer information only.

Operating Instructions

Checking for Leaks

1. Make 2-3 oz. of leak solution by mixing one part

liquid dishwashing soap with three parts water.

2. Connect LP gas tank per “Installing LP Gas Tank”

section.

3. Turn LP gas tank valve to “OPEN”.

4. Spoon leak check solution at all “X” locations

(Figures 1 and 2).

a. If any bubbles appear turn LP gas tank valve to

“CLOSED”, reconnect and re-test.

b. If you continue to see bubbles after several

attempts, turn LP gas tank valve to “CLOSED” and

disconnect LP gas tank, per “Disconnect LP Gas

Tank” instructions, and contact 1.888.753.7137 for

assistance.

c. If no bubbles appear after one minute turn LP gas

tank valve to “CLOSED”, wipe away solution and

proceed.

Placement

Properly positioning your SkeeterVac

device is

important to maximizing performance. Since the

SkeeterVac

device attracts mosquitoes it should be

placed at least 10 feet from your living areas.

Mosquitoes typically live in areas that are shady, wet

and/or moist. Determine the primary mosquito habitat

and place your SkeeterVac

device as close as possible

to it.

If you live in an area with consistent wind, place your SkeeterVac

device upwind from the

primary mosquito habitat.

CAUTION: Tipping danger. Use stakes to secure.

Once you have selected the location, secure the SkeeterVac

device by placing a stake in each

of the (2) front feet.

Maximum performance may require relocating your SkeeterVac

device from time to time. To

move, revmove the stakes and lift SkeeterVac

by post. Set in new location and insert stakes.

FineTune

: Customizing the Lure Output

The amount of octenol your SkeeterVac

device dispenses is important to maximizing

performance. Some mosquito species are highly attracted to octenol while others are less

attracted.

This product contains an easy-to-use feature that allows you to customize the amount of

octenol released to match the species in your environment.

Note: Lure lasts 60 days.

1. Remove rain cover by turning counterclockwise.

2. Remove foil seal from the Finetune

Lure.

3. Place Finetune

back into holder with holes orienting upward.

4. From the illustrations provided on the engine label, select the environment that best matches

the area you are protecting.

5. Position the ring so it points to your environment. (Figures 3a, 3b and 3c).

6. Replace rain cover by turning clockwise.

Important Mosquito Information (continued) Operating Instructions (continued)

Figure 1

Figure 2

Figure 3a

Lure Output: Fully Open

Figure 3b

Lure Output: Half Open

Figure 3c

Lure Output: Closed

Figure 4

Igniter

Button

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Blue Rhino SkeeterVac SV-15 Bedienungshandbuch Seite 7

Kommentare zu diesen Handbüchern